全息师 Holosmith - Power Sword DPS

特性 Specializations

装备 Equipment

装备变体 Equipment Variants

• The Dragon stats pieces are a tiny dps increase, so you can run full Berserker stats if you prefer.
• or slaying sigils when applicable.

消耗品 Consumables

• Slaying potions when applicable.

使用说明 Usage

循环 Rotation

The logic behind this rotation is to maximize your Photon Forge and uptime. You build heat in Photon Forge with ，，and autoattack chains. Using as your last skill and exiting Photon Forge will continue to generate heat for a few seconds without causing you to overheat. Then fill the time cooling down with Sword auto-attacks and your high damage skills such as 和 。 Rinse and repeat when you fall below 100 heat.

Opener

Holosmith can vary the length of its opener by starting at different heats. This enables them to maximise damage by ending a phase just after their Photon Forge burst. Choosing the correct opener for the fight is a matter of experience, so two options are offered here:

40% Heat opener

Try to start with 和 pre-placed

7. → →
9. - optional, more damage but you need to be fast enough to pull it off
10. → → x3
13. if the boss didn't already trigger it
15. 和

90% Heat opener

Try to start with 和 pre-placed

2. 和
7. directly onto the boss (see Notes below for details on how to use this during the rest of the rotation)
9. → → x2

Loop Rotation

1. - skip if it's not off cooldown
4. - This will drift backwards in the loop over time, so use whenever it is available
5. -> -> x2
8. -> -> x2
10. - skip if it's not off cooldown
14. - This will drift backwards in the loop over time, so use whenever it is available
15. - This will drift backwards in the loop over time, so use whenever it is available
18. → → x2 - ideally you want to be above 140 heat when you use Corona Burst so depending on your speed you may need to use more or fewer autoattack chains
19. 和
22. Return to start of loop

视频演示 Video example (with Throw Mine and shield)

Notes

• Under no circumstances should you ever overheat as it will massively reduce your damage output. Try to exit photon forge as close to 149 heat as possible.
• will continue to generate heat for a short time after it finishes, but it will not trigger an overheat if you are not in forge. For this reason, it should be the last skill you use while in Photon Forge.
• Never interrupt your Photon Forge auto-attack chain.
• If you are a little slow with the rotation outside of Photon Forge, you may find that you are not close to 149 heat when you would normally exit. In this case, perform an extra Photon Forge auto-attack chain.
• Use off cooldown. To avoid it detonating instantly, you will need to throw the mine to the edge of the target's hitbox. If you struggle with this, just replace with at step 19 in the loop.
• The cooldown on is longer than the loop, so it will change position in the rotation. Whenever you enter ，use if it is available. If it is still on cooldown the third time you enter in the loop (just before going into Photon Forge), use instead. Both 和 may be omitted from the rotation if you are losing too much heat between Photon Forge uses.
• Use ， 和 off cooldown, but only while in Photon Forge so that you benefit from 。
• (if using) should be used off cooldown.